Compal ACY25 series, Руководство по обслуживанию

Страница: 83 / 175

Disassembly Procedures
The computer has two basic types of cable connectors:
‰
Pressure Plate Connectors
‰
Standard Pin Connectors
To disconnect a Pressure Plate connector, lift up the tabs on either side of the connector’s
plastic pressure plate and slide the cable out of the connector. To connect the cable to a
Pressure Plate connector, make sure the pressure plate is fully lifted and slide the cable into the
connector. Secure the cable in place by pushing the sides of the pressure plate down so the
plate is flush with the sides of the connector. Gently pull on the cable to make sure the cable is
secure. If you pull out the connector, connect it again making sure the connector’s pressure
plate is fully lifted when you insert the cable.
Standard pin connectors are used with all other cables. These connectors can be connected
and disconnected by simply pulling them apart or pushing them together.
Assembly Procedures
After you have disassembled the computer and fixed or repaired the problem that was causing
the computer to operate abnormally, you will need to reassemble the computer.
While assembling the computer, remember the following general points:
‰
Take your time. Most problems arise when you get in a hurry assembling the
computer.
‰
Make sure all cables and connectors are securely fastened.
‰
Before securing the module or other parts, make sure that no cables will be pinched
by screws or the module.
‰
Check that all latches are closed securely.
‰
Make sure all the correct screws are used to secure all components. Using the wrong
screw can either damage the threads on the screw or the head of the screw and may
prevent proper seating of a module.
After installing a component in the computer, confirm that the component and the computer are
functioning properly.
Chapter 5-5