INS_FVT110/BO_REV–
2/15/12
PAGE 3
INSTALLATION AND OPERATION MANUAL
FVT110(M,S)1/BO
CONNECTIONS FOR BOSCH CAMERA FIBER MODULE (continued):
EXTERNAL VIDEO RECEIVER MODULE (FVR110):
1. Connect power to module:
Use +9 VDC adapter included with module, or insert into ComNet rack.
POWER LED should illuminate green.
LINK LED should illuminate red.
VIDEO LED should illuminate red.
DATA LED should stay off.
2. Connect video output to monitor:
Attach to BNC connector labeled VIDEO OUT
3. Connect fiber to module:
Attach Single mode or Multimode fiber to ST fiber optic connector labeled OPTICAL.
4. If Biphase data is used to control the camera then connect data to screw terminal block on module:
Biphase CODE+ should be connected to DIN+.
Biphase CODE- should be connected to DIN-.
Shield should be connected to GND.
NOTE: LINK LED will illuminate green once a link is established over optical fiber with the In-Dome Transmitter module.
VIDEO LED will illuminate green when active signal is detected at the BNC.
DATA LED will flash green when Biphase commands are detected at the data connector.
FIGURE 2 – LED INDICATORS (FVR110 RECEIVER)
LINK
VIDEO
DATA IN
POWER
GREEN
Communication link
has been established
over optical fiber
An active video signal
is present on the BNC
connector.
An active data signal is
present on the pins of
the data connector.
Unit powered up
RED
Communication
link has not been
established.
–
–
–
OFF
Unit powered down.
