Community DA6 Installa on/Opera on Manual — Page 5
DA6
To mount the DA6 to the wall, slip it over the moun ng plate and slide the DA6 downwards to snap it into place
(Figure 2). This completes the moun ng and wiring process.
U n in s ta l l i ng t h e D A 6
Should it become necessary to remove the DA6 from its moun ng loca on, the loudspeaker locking mechanism
must be released via the small hole on the bo om of the DA6 (Figure 4). A speci c tool is not provided for this purpose. Any
simple tool, such as an Allen key or screwdriver, can be used. The tool should be at least 4” (102mm) long and no more than
0.2” (5mm) in diameter (a standard length #1 Phillips Screwdriver is usually an adequate size). Push upwards and hold to
disengage the spring-loaded locking mechanism. While con nuing to push upwards and holding the locking mechanism in
the disengaged posi on, carefully li the DA6 straight up (about 1/2” inch) and o of the moun ng bracket. Once clear of
the bracket, the DA6 can be removed from the wall, the Euro connector disconnected, and the removal tool may be
withdrawn.
Figure 3
Figure 2
Figure 4
