Community Cloud1266, Инструкция по установке и эксплуатации

Страница: 24 / 28

Community CLOUD12 – Installation and Operation Manual - Page 24
the speaker’s paper cone. It will likely require the assistance of a second worker to hold the
CLOUD12 speaker assembly. Alternately, a fixture might be devised to safely support the speaker
frame while fastening it into the C12BB3.
6. Be sure that the neoprene rubber gasket material surrounding the outer edge of the speaker frame
makes contact and seals all the way along the perimeter of the raised square flange on the C12BB3.
7. Insert and start threading all four 10-24 x ½" Philips Truss Head Screws using one #10 Flat Washer
and one #10 Lock Washer as shown in Figure 12. After all four screws have been threaded one or
two turns; tighten screws hand-tight so that the neoprene gasket is evenly compressed. Do not
over-tighten the Philips head screws, but do take care to ensure that they are firmly seated and that
the lock washer has compressed.
8. Check and review that all steps above have been carefully followed.
Figure 26: Aligning the CLOUD12 with the backbox
Figure 27: CLOUD12 installed / gasket compressed