Community Cloud1266, Инструкция по установке и эксплуатации

Страница: 19 / 28

Community CLOUD12 – Installation and Operation Manual - Page 19
The CLOUD12SUB-T ceiling subwoofer is shipped with a 5-conductor cable for connection to the appropriate
autoformer input position. See the figures below for input terminal designation.
Attaching Channel Rail Kits to the C12BB3 Backbox
Community offers rail kits in three popular lengths: 24 inches, 30 inches and 48 inches. Choose the
appropriate size kit to fit the architectural structural supports for the CLOUD12 speaker and C12BB3
backbox assembly. The CLOUD12 speaker system is meant primarily for installation in ceilings, and these
instructions follow that path. Other installation locations, such as in walls, are also possible.
Rail kits can be installed directly to the building structure, and can be used to create additional rigging
solutions. Please remember that when using rail kits for rigging supported by steel wire, rope, chain, or
similar materials, the center of gravity of the assembly might be above the attachment points on the rail kit.
NOTE: The rail itself may not provide sufficient stiffness if rigged from a point located far
from the backbox tabs. Community recommends all mounting and rigging methods be
approved by a qualified Professional Engineer.
Required tools:
• Two 7/16” (11mm) wrenches, socket drivers, or spin-tights (nut drivers).
• Torque wrench (as needed) to verify proper fastener torque.
Figure 20: CLOUD12SUB-T wiring and input panel (70V/100V operation)