Instruction Sheet:
SYSTIMAX 360™ iPatch
®
1100 Type Panel
Installing Panels
1
Panels are shipped with the cabling labels for B wiring already
installed. If the installation uses A wiring, insert the cabling
labels for A wiring in the slots on the back of the panels. Make
sure that the labels are oriented with the right side up (Figure 1).
2
Make sure that the panel bus jumpers are firmly connected to
the panels (Figure 2).
3
Install the panels on the rack using the 4 screws provided
(Figure 3). Be careful not to pinch the panel bus jumpers
between the panels and the rack.
4
Snap the decorative bezels onto the front of the panels.
(Figure 4).
5
Remove the adhesive backing from the cable retainers on the
panel bus jumpers.
6
Connect the panel bus connector on each jumper to the
nearest connector on the panel bus, folding the jumper as
shown (Figure 5). Press the cable retainers against the rack.
Figure 1
Inserting the Cabling Label
Figure 2
Checking the Panel Bus Jumper
Figure 3
Mounting the Panels
Figure 4
Installing the Decorative Bezel
Cabling label
Check the panel bus jumper here.
Mounting screws
Decorative bezel
Note:
The connector is keyed. The polarized tab on the jumper
connector fits into the opening in the header connector on the
panel bus.
Important:
For 2U panels, connect both panel bus jumpers.
Cabling Panels
Figure 6 identifies the IDC (position) numbers and pair numbers for
cabling panels. Table 1 indicates the conductor colors for
EIA-T568A and EIA-T568B wiring applications.
1
Cable each panel. Use a Termination Manager to terminate
each 4-pair cable, following the Termination Manager
installation instructions provided with the panel.
Note:
The Termination Manager provides pair-twist control and
strain relief features to the rear termination area of the panel.
continued
Figure 5
Connecting and Routing the Panel Bus Jumpers
Figure 6
Cable IDC Numbers and Pair Numbers—Rear View of Panel
Table 1
Cable Terminations
IDC#
A Wiring
B Wiring
1
W/BL
W/BL
2
BL/W
BL/W
3
W/G
W/O
4
G/W
O/W
5
W/O
W/G
6
O/W
G/W
7
W/BR
W/BR
8
BR/W
BR/W
Panel bus
Fold the panel bus
jumper as shown.
Panel bus
Panel bus jumper
Cable retainer
Cable
retainer
Polarized tab
Panel bus
jumper
Pair Numbers
Position Numbers
Position Numbers
Pair Numbers
A Wiring
B Wiring
