Ruckus ICX 7750 Switch Hardware Installation Guide
43
Part Number: 53-1003900-10
Installing the Ruckus ICX 7750
Connecting network devices
NOTE
When 10 GbE fiber-optic ports on the Ruckus ICX 7750 are disabled, the laser light remains on even though the port link is down.
Use the following steps to install a transceiver:
1.
Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface (such as an equipment rack) to act as
ground.
2.
Remove the new transceiver from the protective packaging.
3.
Remove any protector plugs from the transceivers and the ports.
4.
Making sure that the bail (wire handle) is in the unlocked position, place the transceiver in the correctly oriented position on the
port, as shown in
5.
Slide the transceiver into the port until you feel it click into place; then close the bail. Transceivers are keyed to prevent incorrect
insertion.
NOTE
Each SFP+ transceiver has a 10-pad gold-plated edge connector on the bottom. The correct position to insert an SFP+
transceiver in the upper row of ports is with the gold-plated edge down. The correct position to insert an SFP+ transceiver in the
lower row of ports is with the gold-plated edge up.
FIGURE 31
Installing an SFP+ transceiver in a port slot
Connecting network devices
Ruckus devices support connections to other vendors’ routers, switches, and hubs, as well other Ruckus devices.
Connectors
For port information, refer to
