CommScope PFU-P-C-O-060-02, Руководство по оборудованию

Страница: 24 / 38

Two Port PoE Extender Hardware Manual
20 This product is copyright © 2017 CommScope, LLC. All Rights Reserved.
3.
While holding the center fiber element in as straight a line as possible, peel the second
conductor element away to the desired length.
4.
For the 12 AWG cable, use a proper 12 AWG or 2MM diameter wire stripper. For the
16AWG, use a 16 AWG or 1.2mm wire diameter stripper.
5.
Use tape or heat shrink to prevent the cables splitting further than the required length.
6.
Ensure the cables are smooth to prevent water ingress issues through the grommet.
7.
Strip the two copper elements to an appropriate length, just as accessing any copper
cable.
8.
For the center fiber element, simply place the strippers at the desired strip location, close
the wire strippers fully once, then open. Now, by hand you may pull the center element
jacket off, revealing the aramid and optical fibers.
9.
Remove excess aramid as desired for termination.
SFP Relationship to Ethernet ports
The SFP relationship to the Ethernet ports is as follows:
•
If both SFPs are connected, the bottom SFP data goes via Ethernet port one (nearest the
SFPs). The top SFP data goes via Ethernet port two.