CommScope PFU-12-C-O-060-01, Руководство по оборудованию

Страница: 24 / 36

PoE Extender Hardware Manual
20 This product is copyright © 2019 CommScope, LLC. All Rights Reserved.
8.
For the center fiber element, simply place the strippers at the desired strip location, close
the wire strippers fully once, then open. Now, by hand you may pull the center element
jacket off, revealing the aramid and optical fibers.
9.
Remove excess aramid as desired for termination.
Connecting the Powered Fiber Cable
1.
Thread the strands through the cap, then thread the strands through the supplied grommet;
the grommet should be positioned approximately 5cm from where the cable component
parts are split out. Use some silicone grease on the grommet, which helps pulling the
strands through the grommet, and provides a seal against water ingress.
2.
When threading the cable through the pass through, ensure the fiber strand is uppermost
when pushing the grommet in to the pass through.
3.
Use tape or heat shrink to prevent the cables splitting further than the required length.
4.
Using the Torque wrench, tighten the screw cap on the pass through. Tighten to torque
5Nm ( 3.69 ft-lb ).
Connecting the Power Strands
1.
Cut the two power strands to length. Remove 5mm of sheath from the two cables.
2.
For the 12 AWG cable, use a proper 12 AWG or 2MM diameter wire stripper. For the
16AWG, use a 16 AWG or 1.2mm wire diameter stripper.
3.
Use tape or heat shrink to prevent the cables splitting further than the required length.
Thread the two cables in to the power connectors and tighten the screws.
Note: Due to the cross-polarity protection, the circuit will work regardless of the input polarity.