Note:
The 216B key tool is not included.
2 Unscrew the dust cap from the cable connector.
3 Pull the dust cap off.
Note:
Field personnel must take care when proceeding to remove dust caps on the full size hardened connector at
the adapter plugs or cables, to prevent contaminant particles entering to the adapters or connector end-face.
5.3.2
Install the Full Size connector
1 Align the drop cable connector with the optical port. The pointer on the drop cable connector should line up with
the notch on the optical port.
2 Insert the drop cable connector into the optical port. If the drop cable connector does not insert all the way to the
bottom of the port, rotate drop cable connector slightly to either side until it slides freely into place.
3 Thread the drop cable connector coupling nut into the optical port and tighten coupling nut until finger tight.
5.3.3
Secure dustcaps
1 Thread the optical port dust cap into the drop cable dust cap.
2 Tighten both dust caps finger tight.
3 This ensures that both dust caps will stay clean when not in use.
5.4
Disconnecting the Full Size connector
1 Unscrew the optical port dust cap from the drop cable dust cap.
page 6 / 11
© 2021 CommScope, Inc. All Rights Reserved
