CommScope LSX, Руководство пользователя

Страница: 13 / 30

ADCP-93-095 • Rev B • April 2018
Page 13
© 2018, CommScope, Inc.
3. Two rubber yokes and either three or four grommets (depending on the kit) are provided
with the cable clamp kit for securing the cable to the panel. Select the grommet that, when
fitted on the cable, as shown in Figure 12 , provides the gap width shown.
Figure 10. Installing a Cable Clamp (7-Inch Module)
4. Open the splice area access door on the rear of the panel and direct the broken out section
of the cable through the cable entry hole into the rear storage area of the panel. Allow the
cable to remain in that position for later routing within the rear storage area.
5. Working on the outside of the panel, where the cable bracket was installed, stack the cable
clamp components on the standoffs, as shown in Figure 10 and Figure 11 , with the cable
secured within the rubber grommet. Position the cable so that the breakout point shown in
Figure 8 and Figure 9 occurs just beyond the rubber grommet.
6. Secure the cable clamp components to the standoffs using standoff screws, as shown in
Figure 10 and Figure 11 .
7. If desired, install a cable shield using any of the three shields shipped with the panel. The
purpose of the shield is to protect the cable where it enters the panel. Figure 13 shows the
CABLE CLAMP BRACKET
(OVERHEAD CABLE POSITION)
YOKE (2)
CABLE
CLAMP
COVER
12-24X
SCREW (2)
STANDOFF (2)
STANDOFF
MOUNTING
HOLE (4)
STANDOFF
SCREW (2)
17525-A
RUBBER
GROMMET
CLAMP
MOUNT
PLATE
CABLE CLAMP BRACKET
MOUNTING HOLES (2)
FOR OVERHEAD
CABLE ENTRY)
CABLE CLAMP BRACKET
MOUNTING HOLES (2)
FOR UNDER FLOOR
CABLE ENTRY)
CABLE
ENTRY HOLE