ADCP-90-516 • Rev B • April 2019
Page 14
© 2019, CommScope, Inc.
Figure 11. Storage Panel Installation on a Wall (2-Deck Chassis Shown)
3. Using the storage panel rear panel as a template, mark the four mounting hole positions on
the wall or plywood with a pencil or a felt-tip pen. See
4. If you are mounting the storage panel on plywood, insert #10
×
1.25-inch wood screws in
the pilot mounting holes and tighten all four screws securely. If you are mounting the
storage panel on a surface other than wood, select appropriate fasteners and attach the
storage panel to the wall surface using the instructions provided with the fasteners.
4
INSTALLING STORAGE PANEL COMPONENTS
Supplied storage panel components include designation labels, bulkhead panel labels, and hole
plugs. Optional components for the storage panel include a key lock and cable clamp kit.
4.1
Designation Labels
Number labels are included with the storage panel for identifying (on the label inside the front
cover) all the storage loops installed in the module.
4.2
Key Lock
The front cover of the storage panel uses a turn latch; however, an optional key lock is available
as a security option. Use the following procedure to install the key lock:
1. From inside the front cover, remove the lock nut that holds the latch to the cover.
2. Remove the latch body from the latch cutout through the front of the cover.
3. Insert the key lock body through the cutout and thread the lock nut onto the key lock body.
16084-A
MOUNTING
HOLES (4)
