860576982
Instruction Sheet
www.commscope.com
Page 4 of 7
Wall Mount Instructions
Note:
The
Redwood
engine can be installed flush against a wall
using a
Redwood
wall mount kit as shown above.
The wall mount kit contains two pieces, a wall mount tray and a drip
pan. Use a ¾" (19mm) plywood backing board (purchased locally).
Plywood must be taller and wider than the wall mount tray and wide
enough to span the wall studs.
1. Attach the
¾
" (19mm)
p
lywood backing board to the wall studs
using screws (not provided) that can hold at least 125 lbs (57kg).
For a typical situation where the drywall is
5/8
" (16mm) thick, a 2"
(51mm) or longer drywall screw on each corner of the plywood is
recommended.
2. Attach the wall mount tray to the plywood backing board using
provided screws.
3. With power disconnected, attach the engine to the wall mount tray
using provided screws. Mount the engine with the input power
connection facing up and the port connectors facing down.
4. Attach the drip pan to the wall mount tray using the provided
screws, and rotate it to the position shown in the installed view of
the wall mount assembly.
5. Connect the cables.
View of Completed
Installation
