M0149AUB_InstInstr_CM AX-OMF7-43-UWi53
Technical Support:
http://www.commscope.com/wisupport
Installation Steps
1)
Position and drill the screw holes of the specified size (one ≥ M35
cylindrical hole, four M6 screw holes).
2) Put plastic expansion pins in the M6 holes first.
3) Feed these two pigtails of this antenna through the hole in the
ceiling tile.
4) Use M4*25 self-tapping screws to lock the antenna to the ceiling
according to the corresponding hole position.
Note: Cable min. bending radius: 40mm
© Copyright 2020 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or
faults.
CommScope reserves the right to change all hardware and software characteristics without notice.
Names of products mentioned herein are used for identification purposes only and may be trademarks and / or registered
trademarks of their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means,
electronical, mechanical photocopying, recording or otherwise, without prior written permission of the publisher.
CommScope, 04-May-2020