FEATURES
ViaAqua® Poly
Reactor
TM
is built with high quality acrylic and an easy to remove lid
with a recessed o-ring. The reverse water flow design eliminates water channeling
through the filter media thus efficiently utilizing filtering media. ViaAqua® Poly
Reactor
TM
comes complete and ready to run with a pump and all plumbing parts.
ViaAqua® Poly
Reactor
TM
is designed to be installed either in-sump or hang on the
tank.
WARNING AND SAFEGUARD
WARNING
»
This product may contain chemicals known to the State of California to
cause cancer and/or birth defects or other reproductive harm. Wash you
hand after handling the product.
»
It is your sole responsability to verify that the plug and receptacle are
clean/free of moisture and salt build up at all times. The receptacle must
be free of water, salt, calcium, and magnesium. Failure to do so may cause
fire and/or loss of life.
»
Do not plug into an extension cord or power strip.
»
A drip loop must be used when plug into any electrical devices. A drip
loop is part of the cord hanging below the receptacle.
»
The national code requires all aquarium equipment to be plugged into
a G.F.C.I. (Ground Fault Circuit Interrupter) electrical outlet. If you do
not have a G.F.C.I., have an electrician install one prior to operating any
aquarium components.
• Read and follow all instructions before using the ViaAqua® Poly
Reactor
TM
to
ensure proper use and application.
• Use this product for its intended use only.
•
Do not operate ViaAqua® Poly
Reactor
TM
without
water. Doing so can cause permanent damage to the
pump.
• You must verify that the receptacle is clean and
free of water, moisture, and salt build up at all
times. Failure to do so may cause electrical arching
resulting in fire or electrical shock.
•
Prior to maintenance on any electrical aquarium
appliance or aquarium, you must disconnect all
Drip loop
1
