5 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Installation (continued)
7
Installing the Fixture
□
Connect the three wires coming from the fixture to
the junction box wires (black - line voltage, white -
neutral and green - ground).
NOTE:
Please select the preferred color temperature
by using the switch behind the fixture. Refer to the
“Changing Color Settings” at the bottom of this page.
8
Connecting the Swing Arms
□
Insert the swing arm’s key hole slot into the
mounting bracket plate’s hanging screw.
9
Attaching the Fixture
□
Feed the junction box and fixture wires through
the mounting bracket plate’s center hole.
□
Raise the fixture to the direction of the arrow on
the swing arm.
10
Securing the Fixture
□
Once the fixture has been raised and is flush to the
ceiling, lock the fixture by moving it towards the
opposite direction it was raised.
Changing Color Settings
(Soft White)
SW
(Bright White)
BW
(Daylight)
DL
(Light Switch)
Switch
1. You can lock in one color temperature, change among multiple
color temperatures, dimm from 10%-100%, memorize the last
color temperature, and reset automatically.
2. Soft White - Bright White - Daylight - Light Switch Marks on the
lamp: SW-BW-DL-Switch
3. When the slide switch is set to SW (Soft White), the color
temperature fixes at 3000K.
4. When the slide switch is set to BW (Bright White), the color
temperature fixes at 4000K.
5. When the slide switch is set to DL (Daylight), the color
temperature fixes at 5000K.
6. When the slide switch is set to SWITCH, the color temperature
can be changed from SW-BW-DL with your existing light switch.
7. To change color temperatures using your existing light switch:
A. Set the slide switch on the back of the fixture to “SWITCH”.
B. Toggle your light switch ON and OFF within 0.5-3 seconds to cycle
though the three different color temperatures.
C. The fixture will remember the last color temperature selected after the
fixture has been on a selected color temperature for 10 seconds and
eventually turned off. To maintain selected color, do not toggle switch
as detailed in the prior step, but leave off for 10 seconds. The next time
the fixture is turned on, the fixture will emit the last color temperature
selected.
8. The reset function is used when using multiple Color Selectable lighting
products operating from the same light switch. In the event multiple fixtures
are not displaying the same color at the same time, fixtures must be RESET
using your existing light switch. Simply toggle the wall switch ON and OFF
7 times within 10 seconds. (ex: Fixture in the ON position, toggle the wall
switch ON and OFF in about 1 to 1.5 seconds. Repeat 7 times.)
