CommBox Interactive Pulse, Руководство пользователя, Страница: 10 / 24

10
+61 2 9975 6001
13
FF FD 22 FF FC 22
FF FD 1F FF FC 1F
FF FB 05 FF FE 05
FF FD 21 FF FC 21
FF FB 01 FF FE 01
FF FD 06 FF FC 06
FF FD 00 FF FC 00
FF FB 00 FF FE 00
FF FD 25 FF FC 25
3.1.3 Authentication (Optional)
If authentication details have been setup, the following request/response sequence will
occur. If no authentication details are configured, this step is skipped.
Authentication will be setup in the system menu in the screen, but is blank by default. The
double quotes in the table should be omitted. They are there to show any white space
required.
Request from Screen Respond With
"login: " <username>\r
"Password:" <password>\r
<username> and <password> are substituted with the username and password.
3.1.4 Welcome (Required)
Once the session is ready, and any authentication is successful, a welcome message is sent
by the screen to inform the client that it can start sending commands.
The welcome message is: Welcome to the CommBox Control Protocol\r
4.3.3 Remote Control Instructions
4.3.3.1 Install Batteries
1) Remove the back cover of the battery compartment located on the back of
the remote control.
2) Place AAA type batteries according to the diagram in the battery
compartment, making sure positive and negative battery terminals are
placed correctly ("+"to"+", "-" to "-"); please do not mix an old battery with a
new one.
3) After the batteries are placed, replace the back cover of the battery
compartment.
4.3.3.2 Range of the remote control
Remote control can work normally within the range of 8 meters, 30 degrees left and
right from the remote-control receiver.
In order to protect the environment, please recycle used batteries.
Control Panel
8
3) Remote Control Instruction
Install Batteries
1) Open back cover of battery component on the back of remote control.
2) Install AAA type battery according to the corresponding electrode, make sure battery
positive and negative pole are correct ("+"to"+", "-" to "-"), please do not mix using old
and new batteries.
3) After battery is installed, close the back cover of battery components, and make the
following clip buckled to the bottom.
Range of remote control
Remote control can work normally within the range of 8 meters distance,
30 degrees left and right from the remote-control receiver.
In order to protect environment, please dispose waste battery into recycling box.