Command Light KNIGHT KL415A, Руководство пользователя

Страница: 13 / 41

USER GUIDE
13
Location Requirements
The standard KNIGHT
2
Models 415A can be mounted on any location that is 47” x 23”. The surface
should be flat or have only a slight crown. For a recessed installation allow for a minimum of 58” x
29”. Consult with factory before construction of recessed installation. Verify all dimensions before
installation to ensure proper operation of light will not infringe on other installed components. For all
other installations refer to the dimensional drawing included in the back of this guide that represents
your particular model of light. The drawings reflect the dimensions of the “working envelope” of a
typical light tower. Make certain sufficient clearances are incorporated in your installation to allow for
variations (vehicle body flex, environmental conditions, future servicing needs, etc.) If your light is not
represented, call the factory prior to beginning any construction of a recessed installation.
Four mounting bolt holes are required. Additional holes may be drilled in the frame ends if necessary to
clear obstructions.
Access holes for the power cord cabling should be in close proximity to the relay box access holes on
the light. Installing the cords with a sweeping 90º or 180º bend will provide better results.
The control box holster should be mounted in an area shielded from the weather. Allow a minimum of
10” clearance above the control box holster mounting location for easy access to the controller.