Slide the housing back onto the baserail making sure the motor & baserail are in the
correct channel. Be cautions of pinching motor/REX wires.
Re-install (2) screws on mounting bracket with
5/16” nut driver.
Connect your VD 8’ lead (CAT or VD retrofit) or you can
remove the VD connector to hard wire take stripped wire end
and push into the push & go connector
CONTINUED
Line up slots in motor mount to drop onto
existing tabs in baserail.
7.
10.
11.
9.
Visually confirm hooks are attached to roll pin. If not
repeat Step B.
8.
# 2 0 3 8 7 _ C
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w. c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
