Cylindrical housing
Slide the motor mount into the device. Feed the
acme thread into the cylinder clockwise.
7.
Connect your 8’ lead (CAT retrofit) or you can remove
the VD connector to hard wire take stripped wire end
and push into the push & go connector.
9.
Hook up to power & set your PTS.
11.
Slide the filler plate back on to re-install
12.
Continue feeding the acme thread until the holes on
the motor mount line up to the existing dogging holes.
Next, install the (2) screws provided.
8.
Next, plug in the push & go connector into
the MM4S.
10.
Installation Instructions
Setting PTS
Step 1-
Select your preferred torque mode (ships in standard torque) Press the device push pad to the
desired setting. (Recommend to fully depress and release 5%, giving the device room for
changing door conditions.)
Step 2-
While depressing the push pad, apply power. (i.e. presenting the credential to the reader).
Step 3-
Continue to keep pad depressed, the device will beep 6 times. After the beeps have
stopped, release the pad and now the adjustment is complete. If not to your liking repeat
the three steps.
Step 4-
Once you found the correct location, flip the dip switches to off to lock programming.
# 2 0 0 9 2 _ F
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w. c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
mm4s switches
2
on
on
off
STANDARD TORQUE
HIGH TORQUE
PTS PROGRAMMING LOCKED
PTS PROGRAMMING on
off
1
