Make sure to route power wires under back
activating arm.
12.
While holding solenoid in place, tighten all (4) screws
to secure mount to baserail.
13.
14.
Plug into power & test. After confirming unit works
properly. Add wire tie & strain relief pad to secure
power cable.
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w. c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
15.
Add power connector to power wires, push them
into the connector make sure the tabs on the wire
pins are facing up. The tabs will lock pins into the
connector.
TOP
TAB
