Comm Net Systems GMT 125-15A, Руководство по установке и эксплуатации

Страница: 15 / 26

GMT 125 - 15/15 FUSE PANEL
SETUP AND OPERATION MANUAL
OPERATION - PAGE 9
Section 5: Operation
5.1 Meter Module
The GMT 125 - 15/15 fuse panel is available with an LCD meter module that displays
bus current, total bus load, and an exclamation mark indication when a major alarm
occurs.
Screen contrast can be adjusted from 0-100 (increments of 5) .
5.2 Review System Status via the Embedded Web
Server
This section applies to the GMT 125 - 15/15 products with the optional embedded
web server installed. If a panel does not have an Ethernet web server but you would like
to add one, or if you are unsure if this option is installed on your panel, contact Comm/
net Support at support@commnetsystems.com or 1-800-274-0544.
The optional embedded Ethernet module provides remote monitoring via IP-based
Ethernet networks and a web browser. To view the system status, you will need to
connect the Ethernet port on the rear of your GMT 125 - 15/15 fuse panel to your
network. See "4.8 Installing the Network Cable" on Page 8 for information on installing
the network cable.
By default, the Ethernet module is configured from the factory with a static IP address
and network settings, as defined below.
5.2.1 Default Static Network Settings
Use these default settings to set up a local network to communicate with the
embedded web server:
y
IPV4 Address: 192.168.123.123
y Subnet Mask: 255.255.255.0
y Default Gateway: 192.168.123.1
y Primary DNS: 192.168.123.1
y
Secondary DNS: 8.8.8.8
Once you establish a connection to the embedded Ethernet module, use the
following credentials to gain access to the protected data and administrative pages:
y Username:
root
y Password:
password