COMFORTPOOL PRO+10, Руководство по установке

Страница: 14 / 42

14
- Press
“Mode” again “E” “40”. Press “SET” to enter Max. temp. setting. Press

to alter.
Press “SET” again to
confirm.
- Press
“Mode” again “F” “2”. Press “SET” to enter Split temp. setting. Press 
to alter.
Press “SET” again to
confirm.
- Press
“Mode” again “G” “-10”. Press “SET” to enter Ambient temp. protection setting. Press 
to alter. Press
“SET” again to confirm.
Further explanation of PCB connections.
4. Clock setting
Under running or standby status, p
ress “SET” for 5 seconds, get a sound “B”. Press

to alter hour. P
ress “SET”
again to alter minute.
Press “SET” again to confirm.
5.Timer setting
Under running or standby status, press

for 5 seconds,
get a sound “B”. Press 
to alter hour of timer ON. Press

again to alter minute of timer ON. Press

again to alter timer OFF. 103
5.2 The functions of controller display
Setting operation parameter
Under standby status, press
“Mode” button 5 sec. to enter Operation Parameter setting interface;
Press
“Mode” again to start setting (parameter from 00-D, see the Operation Parameter Table);
Under parameter setting. Press

or

to set data;
Note : If no motion is detected on the display for 10 sec, the LCD will display water-in/water-out temp.
(under running) or ambient temp. (under standby status).
Under running status, you can press
“Mode” 5 sec to check current parameter, but you cannot change data
of parameter!
Remarks: Standby status means the unit is connected to electricity, but is not running.