COMFORTPOOL BASIC 10, Руководство пользователя

Страница: 21 / 30

|
EN
21
2. Installation instructions
2.1. Assembly of water pump and base plate
Secure the water pump to the base plate with the provided pump mounting hardware (figure 1).
2.2. Pump fittings assembly
1. Refer to figures 2-5.
2. Screw the 1¼
" -1½ " hose connector into the center port of the water pump. Ensure that the O-ring A is
installed between the port and the connector.
3. Remove the threaded ring (collar) on the outer opening of the pump.
4. Place O-ring B in the groove around the hair and lint strainer basket.
5. Place the transparent hair & lint strainer cover in place and then screw the threaded ring (collar) back on
securely over the cover.
6. Insert O-ring C (1¼ " ) inside the outward facing opening of the transparent hair & lint strainer cover.
7. Screw the 1¼ " -1½ " hose connector into the opening of the transparent hair & lint strainer cover.
2.3. Filter tank assembly
1. Place the base plate and pump in the location where the filter pump will be located for normal operation,
within reach of the pool filter and return hoses but with a sufficient safety margin from the edge of the pool.
2. Attach the filter tank to the base plate as shown (figure 7). The feet on the bottom of the filter tank fit within
the holes provided on the base plate.
3. Insert the tank separator plate inside the main tank in the guides provided (only for model BASIC 6) .
2.4. Filling the filter tank
1. Refer to figure 6.
2. Position the filter pump assembly to the location you have dedicated for its
operation .
NOTE: Do this before you fill the chamber with sand as the unit will become heavy and difficult to move
around.
3. Check to ensure that the bottom strainer is correctly positioned.
4. Check to ensure that the tank separator plate is seated properly.
5. Fill the sand chamber half full with water.
6. Pour filter sand with a particle size of 0,40
– 0,80 mm into the sand filter chamber being careful not to
allow any sand to enter the filtered water chamber.
2.5. Closing the filter tank
1. Refer to figure 7 and 8.
2.
Ensure the main tank seal around the top of the filter tank is in good condition and securely seated in the
groove
. Be sure the groove is free of sand .