Comfortflame.US.com
900562-00B
11
INSTALLATION
Continued
INSTALLING OPTIONAL BLOWER ACCESSORY
NOTICE: The firebox identification label (including
model number, serial number, clearances, etc.) is
located in the right side screen pocket area on the
front of the firebox. See
Figure 19, Page 14
.
NOTICE: If a log set is installed in the firebox, discon-
nect log set from gas supply and remove from firebox.
Contact a qualified service person to do this.
Note:
Appearance of firebox may vary depending on model.
There is one (1) blower accessory option for use with this fireplace.
Blower accessory model BK . Model BK is a rotary squirrel cage type
blower with magnetic attachment and variable speed control.
Wiring Instructions
1. Remove electrical cover plate with bushing from fireplace by
removing 2 sheet metal screws as shown in
Figure 11, Page 13
.
2. Slide power source wiring through electrical bushing opening and
electrical cover plate and make all necessary connections.
3. Slide all wiring connections in electrical housing as shown in
Figure 11
.
4. Secure electrical cover plate with screws previously removed.
Note:
Electrical housing and cover plate have sharp edges. Wear
protective gloves.
Figure 11 - Fan Switch-Electrical Bushing
Electrical
Bushing
Electrical
Cover
Plate
Electrical
Housing
Wire Nut (3x)
(Not Supplied)
Outer Wrapper of
Fireplace
Electrical Cover
Plate and Electrical
Bushing
Fireplace Chassis
Ground
To Power
Source
Receptacle
(Supplied)
Power Source Wiring
(Not Supplied)
Pre-wired Receptacle and
Ground
Sheet
Metal
Screws
Figure 12 - Removing Access Cover Plate
Duplex Electrical Outlet
Figure 13 - Accessing Duplex Electrical Outlet Installed in
Bottom Right Side of Firebox
Access Cover
Plate
Screws
Accessibility to the bottom on 36" and 42" models, can be gained
through the access cover plate on the bottom front of the firebox
hearth. Remove the screws to expose the rectangular shaped access
panel
(see
Figure 12
)
. The sides and back refractory brick liner pieces
do not have to be removed (if installed). Lift access panel out by using
finger holes. Blower accessory BK can now be installed.
WARNING: If there is a duplex electrical outlet
installed in the right side of the bottom of the fireplace
base area
(see Figure 13)
, be sure that the electrical
power to the outlet is turned off before proceeding
with blower installation. Failure to do this may result
in serious injury.
