3
STEP 4
Attach the left armrest (C) to the seat cushion (B) and back
cushion (A), using the screws (M) and the screw covers (
I
)
as shown. NOTE the washer (J) is used when attaching
armrests to the back cushion. Repeat for right armrest (C).
ASSEMBLY INSTRUCTION (60-582105)
DO NOT TIGHTEN SCREWS UNTIL COMPLETELY ASSEMBLED
STEP 2
Align seat plate (D) over pre-drilled holes under seat cushion
(B). (NOTE the position of seat plate handle to seat cushion
FRONT). Attach seat plate (D) to seat cushion (B) using two
screws (L), and two screws (K) as shown. Tighten securely
with allen wrench (N).
STEP 1
Insert casters (G) into holes of star base (F). Insert gas lift
(E) into center hole of star base (F). Place gas lift cover (H)
over gas lift (E) as shown.
STEP 3
Place the back cushion (A) on a flat, clean surface such as a
table. Position the seat cushion (B) as shown and align the
four holes in the back and seat cushion together. Connect
the seat cushion to the back cushion using four screws
(L) as shown. Do not fully tighten until after armrests are
attached (see step 4).
Seat front
Seat plate
handle
G
F
E
H
FRONT
B
D
L
K
L
B
D
A
I
M
J
M
I
C
C
A
B
NOTE: To install casters, apply
pressure to base of caster
using your thumb as shown
