- 11 -
Version: May 2011
OPERATION
• Test the GFCI before each use.
(Refer to the instructions provided in
the Maintenance section of this
manual.)
• Plug into a properly grounded
receptacle.
• Do not use extension cords.
Temperature Control
1.
During normal operation, the
control display on the top of the
power pack displays the current
water temperature.
2.
To set the desired water
temperature, press and release the
up or down heat button. The display
will flash the desired water
temperature
set point. To change the set point,
press the up or down button once for
each degree of water temperature, to
a maximum of 104ºF (40ºC).
3.
After a few seconds pass without
pressing either heat button, the
display will return to the current
water temperature. The spa will
begin heating to the desired water
temperature at a rate of
approximately
1 to 1-1/2 degrees F
per hour.
4.
The spa is made to hold the set
temperature. Do not lower the
temperature set point after use.
The heater will turn on and off
automatically to maintain the desired
temperature.
5.
In case of electric power
interruption, the spa temperature set
point will default to 100ºF when
electric power is restored.
Turbo Operation
To turn the turbo wave pump on or
off, push the on/off button. Look to
see if the spa blows bubbles
uniformly all the way around the spa.
The turbo wave pump will
automatically shut off after 15
minutes of operation. When the turbo
wave blower system is activated, the
blower pump is pumping outside
ambient air into the spa, creating
much of the action in the spa. Some
cooling of the water will occur as the
turbo wave blower operates. This is
normal and the heater will recover
lost temperature after use.
Remember, at elevated
temperatures, 15 minutes soaking
time is considered safe.
The spa power pack contains a filter
to help keep the water in the spa
clean. If the filter becomes dirty or
clogged, water flow through the
power pack will be restricted. This
may prevent the spa from heating
up. Refer to the Maintenance section
of this manual for information on
checking and cleaning the filter.
Cover
After use, place the cover on the
spa. Lock the plastic clips in eight
locations on the outside of the spa.
Always leave the cover locked and in
place when the spa is not in use. The
cover is not a replacement for adult
supervision. Always supervise young
children in and around water
.
NOTE: The
cover must be in place for the spa to heat
up.
Meijer.com
