5
5
www.comfortzoneproducts.com
TIMER FUNCTION:
The Timer function allows you to set the length of operation from
1 to 12 hours. Each time the TIMER button is pressed the length
of operation will increase 1 hour. The duration the timer is set for
will be displayed on the LED screen in hour increments.
TO TURN THE TIMER FUNCTION OFF:
Press the TIMER
Button continuously until the LED screen displays "O".
NOTE:
The timer function is not an excuse to leave the heater
unattended.
NOTE:
Heater will cycle on and off to maintain room temperature.
The first time you operate the unit, it may smoke slightly. This is
due to residual cleaning agents used to clean the element when
the heater is manufactured. This is normal and does not indicate
a problem with the unit. This condition will stop after the heater
has been in operation for a few minutes.
FAHRENHEIT OR CELSIUS DISPLAY:
To switch the display between Fahrenheit and Celsius, press
the °F/°C on either the unit or the remote.
INSTALLING THE HEATER:
LOCATING THE HEATER:
Install the heater out of traffic areas, maintaining the clearances
stated in
Figure 1
above. The air flow from the heater must not
be restricted or obstructed by any items in the room. When
more than one heater is used in an area, the heaters should be
arranged so that the air discharge of each heater supports the
air flow of the others to provide best circulation of warm air, as
indicated below in
Figure 3
.
BRACKET INSTALLATION FOR CZ225ER AND
CZ230ER SERIES:
Refer to
Figures
4a and 4b.
1. Locate a ceiling joist or other firm structural element or
support to mount the heater and point at desired direction
of air flow.
2. Drill a ¼” pilot hole in the ceiling joist for the screw(s).
3. Place the screw(s) and washers as shown in the
Figures 4a or 4b.
Figure 4a:
For Single-Screw Mounting (center bracket
hole only).
(If you want to swivel the heater, a longer Lag bolt may be
required to properly secure the heater, not included.)
Figure 4b:
For Double-Screw Mounting (both off-center
Figure 3
Figure 4a: Single-Screw Mounting, To Allow Swivel
CEILING JOIST
WASHER
WASHER
BRACKET
3/8" DIAMETER
LAG BOLT
Figure 4b: Double-Screw Mounting, For Fixed Position
CEILING JOIST
WASHER
BRACKET
3/8" DIAMETER
LAG BOLT
holes are used).
HANGING THE HEATER IN THE BRACKET
1. Lift the heater into the mounting bracket and align the lower
bracket holes with the threaded holes nearest the heater’s
center.
2. Thread a large knob-screw through the hole on each side of
the bracket.
3. Aim the heater horizontally or tilted by aligning the upper
bracket holes with the top threaded holes on the heater
Figure 5
Use top slots/hole in
bracket and small
knob-screws if heater
is to be tilted down.
Adjust louvers up or
down to control air flow.
Remove screws from the
panel to access power
block, See
Figure 7.
