4
4
www.comfortzoneproducts.com
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser against
defects in quality or workmanship for a period of one year
from the date of original purchase. If this unit fails because of
a manufacturing defect within 30 days of purchase, return the
unit, with your receipt, to the retailer. After 30 days, but within the
warranty period, if the unit was purchased within the continental
United States, return it, freight prepaid, to World and Main for
repair or replacement. If the unit was purchased outside the
continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused by
misuse, abuse, overheating or alteration. Repairs made by
anyone other than World and Main are not covered in this
warranty. World and Main will not be held liable for any losses
due to neglectful operation. All implied warranties, including
the warranties of merchantability and of fitness of purpose, if
applicable, are hereby limited in duration to the period of one
year from the date of original retail purchase. Some states do
not allow limitations on how long an implied warranty lasts, so
the above limitations may not apply to you. Incidental or
consequential damages arising from a breach of either express
or implied warranties are hereby disclaimed and excluded. Some
states do not allow the exclusion of limitation of incidental or
consequential damages, so this limitation or exclusion may not
apply to you. Upon the expiration of this warranty all such liability
will terminate. No other warranties are expressed or implied.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. No informal
dispute settlement mechanisms are available. This limited
warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800‑221‑6895
www.comfortzoneproducts.com
Rev. 09/2021
CARE AND MAINTENANCE:
CLEANING:
CAUTION
– Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or
abrasive cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES
IN WATER. Allow fan to dry completely before use. Periodic grille
cleaning with a vacuum will prevent dust build up. The motor is
sealed and does not require any interior maintenance, cleaning
or lubrication.
MAINTENANCE:
The internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
REPAIR:
DO NOT USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
STORAGE:
Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage.
FUSE REPLACEMENT:
This product employs overload protection (fuse). A blown fuse
indicates an overload or short‑circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per the
user servicing instructions (follow product marking for proper
fuse rating) and check the product. If the replacement fuse
blows, a short‑circuit may be present and the product should
be discarded or returned to an authorized service facility for
examination and/or repair.
1. Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of
attachment plug towards blades (see
Fig. 2
).
3. Remove fuse carefully. Use a small tool to pry the end of the
fuse from holder cavity. Be careful not to break glass window.
Slide Cover to Open
Figure 1
Figure 3
Figure 2
Slide Cover to Open
ASSEMBLY INSTRUCTIONS:
(cont.)
FUSE REPLACEMENT:
(cont.)
STEP 7:
Press remaining Grille Clips
onto Rear Grille to securely
attach Front Grille. Do not
operate fan without Grille in
place.
STEP 8:
Secure Wall Bracket to the
wall in the desired location.
Use proper anchors for the wall
material selected, following the
manufacturers instructions.
Mounting bracket to wall studs
is recommended.
STEP 9:
Hang fan on wall bracket.
Place Bracket Screw through
fan and thread screw onto
bracket.
4. Replace fuse.
WARNING:
Risk of fire. Replace fuse only with
identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6 mm x 10 mm). Be
sure fuse is properly seated within its cavity.
5. Close fuse cover by sliding it back to its original closed
position.
Grille
Clip
Mount
Securely
to Wall
Bracket
Screw
