Power Button
•
Press the power button to turn the main power to the unit ON or OFF.
•
When the unit is turned ON, the lights under the emberbed will light to indicate the unit has
power.
M
Flame Brightness Button
•
If the unit is powered OFF you can press the flame brightness button to power ON the unit.
The emberbed will grow at the lowest brightness setting unless a different setting was saved in
the memory.
•
Temperature Button
•
The temperature button controls the heater thermostat.
•
If the unit is powered OFF, you can press the temperature button to power ON the unit. The
emberbed will glow at the lowest brightness setting unless a different setting was saved in the
memory.
•
Press the temperature button again to scroll through the pre-set temperature settings:
–
Fahrenheit: 65, 70, 75, 80, 85, 90, OFF.
–
Celsius: 18, 21, 24, 27, 29, 32, OFF.
•
Hold down the temperature button for 5 seconds to toggle between Fahrenheit and Celsius. A
small “F” or “C” will display next to the temperature.
Timer Button
•
The timer button should be used to set the countdown for the unit's main power.
•
If the unit is powered OFF, you can press the timer button to power ON the unit. The emberbed
will glow at the lowest brightness setting unless a different setting was saved in the memory.
•
Press the timer button again to scroll through the timer settings, which are: 30, 1h, 2h, 3h, 4h,
5h, 6h, 7h, 8h, 9h and OFF.
•
When the timer reaches zero, it will turn OFF the main power and will maintain the settings in
memory.
Memory Function
•
When the unit is powered OFF, all function settings (excluding timer) will be saved.
•
When the unit is OFF, pressing the power button once on the insert control panel or on the
remote control will turn the unit ON and "wake up" the saved function settings.
•
When the unit is OFF, press any function button to "wake up" the individual function at the last
saved setting. Press the button again to adjust it and press the main power button on the
insert or on the remote control to turn the unit OFF and save the new setting into memory.
•
When the unit is powered ON, the LED will show the saved temperature setting. If a temperature
setting was not saved, it will show the flame brightness setting saved in memory. If neither one
has a setting saved to memory, then only the emberbed will glow (as a power light indicator).
•
To reset the memory, hold down the main power button for 5 seconds at any time. When this
happens, the LED readout will blink with four zeros three times.
•
Another way to reset the memory is to unplug the unit from the wall.
Press the button again to scroll through the flame brightness settings,1 (lowest) through 5
(brightness).
5
OPERATING INSTRUCTIONS