www.desatech.com
115580-01A
10
INSTALLATION
Continued
9. Fasten stove bottom to stove with four (4)
M6 x 1 - 25mm bolts. Use a flat washer and
lock washer with each bolt. Tighten bolts into
threaded holes on stove body (see Figure 10
and Figure 8 on page 9). Use an adjustable
wrench or a 10mm socket.
10. Attach stove door by inserting step bolt
through door hinge pivot holes and into
threaded hole in stove body (see Figure 11).
Use an adjustable wrench or a 12mm socket to
fasten step bolt. Tighten step bolt until snug.
Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with
two M8 hex nuts) into threaded hole on stove
body (see Figure 8, page 9). Use an adjustable
wrench or a 12mm socket. The catch bolt has
two hex nuts attached to it (see Figure 12).
The top nut is a bolt stop and the bottom nut
is for door leveling adjustment.
12. Check general catch bolt alignment with door
claw. Make final adjustment and door leveling
after stove is in normal standing position.
13. Carefully lift stove back up on its four at-
tached legs.
Figure 9 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Figure 10 - Attaching Stove Bottom
Bottom Of
Stove Unit
Bolt
Washers
Stove
Bottom
14. If available, install gas log heater inside stove
cavity before installing the back panel (see
In-
stalling Gas Log Heater Into Stove
, page 11).
15. Fasten back panel to stove with six (6) M6 x 1
- 20mm bolts and washers. Make sure product
identification label is located on the outside in
lower left-hand corner.
Figure 11 - Attaching Stove Door
(Appearance May Vary Depending on
Model)
Step
Bolt
Door
Hinge
Threaded
Hole
Stove Door
Stove Bottom
Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
Adjusting
Nut
Bolt Stop
Catch Bolt
Door Claw
Door
Figure 12 - Catch Bolt and Door Claw
Orientation
