Comfort Glow GLD2466R, Руководство пользователя

Страница: 19 / 40

18
INSTALLATION
Installation Items Needed (Not Provided)
Fig. 15 - Attaching Flexible Gas Line
to Equipment Shutoff Valve
Flexible Gas Line or
Black Pipe to Heater
Cabinet Regulator
To Regulator
• 8'' Adjustable Wrench
• 8'' Pipe Wrench
• 1/2'' Flexible Gas Line (24'' Min.) or 1/2'' Black Pipe
• 90 Deg. 1/2 NPT x 3/8'' Flare Fitting or 3/8'' NPT x 1/2 NPT Street Elbow
• Sealant (Resistant to Propane (LP) Gas)
• Shut Off Valve
• Allen Wrench
1) A variety of options are possible for routing the Gas Connection Lines depending on where
your Gas Supply line is located.
2) Identify the gas inlet on the Heater that corresponds to the fuel type for your installation. Re-
move the threaded plug by turning counterclockwise.
Install a 90 degree fitting - not included). Be sure to use a gas resistant sealant on the 3/8 NPT
fitting. Position the fitting so the inlet line can be attached without binding.
3) Install the Gas Line to the 90 Deg. fitting and attach to the Shut Off Valve.
4) Check all connections for gas leaks.
5) Install receiver and plastic Heat shield by attaching the (2) wires from the receiver to the (2)
wires from the Gas Control Valve insuring you match the wire colors. Place the receiver on the
fireplace floor adjacent and slightly behind the Gas Valve control knob with the sensor eye fac
-
ing toward the room.
NOTICE: Most building codes do not permit concealed gas connections. Check
your local building code prior to using a Flexible Gas Line for this installation.
CAUTION
: Use pipe joint sealant that is resistant to gas (PROPANE or NG). We
recommend that you install a sediment trap in a supply line. Locate sediment trap where it is within
reach for cleaning and not likely to freeze. Install in the piping system between fuel supply and
heater. A sediment trap traps moisture and contaminants. This keeps them from going into heater
controls. If sediment trap is not installed or is installed incorrectly, heater may not run properly.
CAUTION
: Avoid damage to regulator. Hold gas regulator with wrench when
connecting into gas piping and/or fittings. NG Models: 6 in. to 14 in. W.C. Gas
supplier provides external regulator for natural gas.
Propane (LP)
Gas Inlet
Natural Gas (NG)
Inlet Location