COMFORT-AIRE Comfort Air, Инструкция по установке и эксплуатации

Страница: 4 / 24

4
WINDOW INSTALLATON
INSTALLATION
6
Lower window sash
Top bar
Level
Window sill Bottom bar
Leveling bracket
SIDE VIEW
1 1/4” space
Sill edge Screw
Filler panel
5/8” wood screws
Lower window sash
Upper window sash
Window sill
Plastic foam seal
7
INSIDE VIEW
5.
Keeping a firm grip on air conditioner,
carefully center air conditioner in window
opening with the bottom bar sitting
behind window sill. Be sure cabinet
maintains an outward pitch. Air
conditioner should slant slightly
downward on the outside as shown by
half a bubble off on a carpenter’s level.
This outward pitch prevents water from
entering the room
(Fig. 6).
6.
Close window until it touches behind air
conditioner top bar. Slide filler panels
outward until they touch window sash
tracks. (Do not release grip on air
conditioner until lower window sash is in
final position)
(Fig. 7).
7.
Secure top of filler panels by driving 5/8”
long wood screws through top mounting
holes into window sash
(Fig. 7).
8. Secure bottom of filler panels by driving
5/8” long screws into window sill through
filler panel tabs
(Fig. 7).
9. Cut plastic foam seal to width of window
and install between upper and lower
window sash
(Fig. 7).
10.
Use sealant to fill any minor openings.
Installation in Minimum
Width Window
1. Remove both filler panels from air
conditioner cabinet
(Fig. 3) .
2.
Refer to steps 1 through 7 of preceding
instructions
(Pgs. 4 & 5) .
3. Close window until it touches behind air
conditioner top bar
(Fig. 6) .
4. Fasten lower window sash to window
frame (use finishing nails, wood screws,
or “L” brackets)
(Fig. 7) .
5. If filler is required on sides of air
conditioner, cut plastic foam seal to size
and fill both sides.
6.
Cut plastic foam seal to width of window
and install between upper and lower
window sash
(Fig. 7) .
7. Use sealant to fill any minor openings.
Consult your authorized dealer or importer for
alternative installation instructions.
CAUTION
Do not drill a hole in bottom pan. Unit is
designed to operate with approximately 1/2” of
water in bottom pan.