9
8
4. Using your Monitor for the First Time
Use only 1.5V “AA” alkaline batteries with this device.
1. Press the hook on the bottom of the battery cover and lift the cover off in
the direction of the arrow (Picture-04).
2. Install 4 “AA” size batteries and make sure the + (positive) and - (negative)
polarities match the polarities of the battery compartment, then close the
battery cover.Make sure that the battery cover is securely in position.
4.1 Activating the pre-installed batteries
Battery Installation
Battery replacement
Picture-04
Insert the cuff tube into the opening on the left side of the monitor indicated
by the drawing of a cuff.
4.3. Cuff tube connection
Low Battery Indicator
1.When the Low Battery Indicator appears on the display, turn the monitor off
and remove all the batteries. Replace with 4 new batteries at the same time.
Long-life alkaline batteries are recommended.
2.To prevent the damage of monitor from leaked battery fluid, please take out
of battery if the monitor unused in a long time(generally more than 3 months).
If battery fluid should get in your eyes, immediately rinse with plenty of clean
water. Contact a physician immediately.
3. Dispose of the device, components and optional accessories according to
applicable local regulations. Unlawful disposal may cause environmental
pollution.
After you load the battery or connect power for the monitor,long press the
SET button for more than 3s, and then you can start to set.
4.2. System Settings
Setting the User:
Press the MEM button to select User A or User B. When display A (/B) on the
screen, press the MEM button to switch to user B (/A). Press the SET button
to confirm.
Setting the Year:
When the year display is flashing, press the MEM button continuously and it
will increase continuously 1 by 1 until 2049, and then return the original year ,
once the year set is OK, press SET button to confirm.
Setting Month/Date:
Initial Month/Date is 1/01, when the Month display is flashing, press the MEM
button, the month will increase by 1, press SET button to confirm, and do in
the same way to set the date. Press SET button to confirm.
Setting Time :
When the hour display is flashing, press the MEM button, the hour will
increase by 1, press SET button to confirm, and do in the same way to set
the minute. Press SET button to confirm.
Setting Volume:
When display with SP is flashing, press MEM button to switch volume 1,
volume 2, volume 3 or OFF. Press SET button to confirm.
Record Delete:
When you checking the memory data, long press MEM button to delete
existing user measurement data.
Note:
You can’t delete all measurement record from the monitor storage at one
time, if you decide to delete the all record, please keep the record in another
way, in case you need it some days later. Take the battery out won’t lead to a
record missing.