Comfee CDC17P2AWW, Инструкция по эксплуатации

Страница: 2 / 33

or
1
Water Inlet
Drain Pipe
QUICK START GUIDE
Please read the entire manual for detailed operating instructions.
Connecting to Power Supply
The power required is 120VAC 60Hz, 10Amp circuit.
Place the end of the drain Hose into a sink or bucket.
Adding Water to the Tank
The water tap symbol will be on if there is not enough water in the tank.
until the unit beeps rapidly for 3 seconds and is off, which means the tank is filled.
There are two ways to add water into the tank:
1
2
Add water into the tank automatically by connecting inlet hose to the tap.
Open the cap and slowly add water into the tank manually by using water container.
Note:
Before adding water, you need to press the power
button to turn on the diswasher
or
2
The water tap symbol will be on if there is not enough water in the tank. Add water
IMPORTANT:
Drain hose installation
Faucet Adapter
or
Install one end of drain hose to the drain pipe at the rear of the machine
and then tighen the drain hose clamp by hand to secure it.
Secure the drain hose to sink or
bucket with supplied suction cup.
Remove the rubber plug from the drain pipe at the rear of the machine.