Comfee CDC17P2AWW, Инструкция по эксплуатации

Страница: 17 / 33

Turning On The Appliance
Starting a wash cycle...
Draw out the basket(see the section entitled "Loading the Dishwasher").
Pour in the detergent (see the section“Fill the detergent”).
Insert the plug into the socket. The power supply is 120VAC 60HZ,
Press the power button to turn on the appliance,
Connect the inlet hose to the tap, make sure that the water supply is turned on
to full pressure, or add water to the tank manually.
Select a suitable program according to the “Wash cycle table”;
If a program is selected, the response light will illuminate. Then press the Start/
Cancel button, the dishwasher begins to start.
Change The Program
A wash cycle can only be changed if it has been running for a short time otherwise,
the detergent may have already been released and the dishwasher may have
already drained the wash water. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be refilled. To reset the dishwasher, follow the
instructions below:
1. Press and hold Start/Cancel button for more than 3 seconds, the machine will
will be stand by state.
2. Press CYCLES button to select the desired program.
3. Add new detergent if the wash water was already spraying.
-1 7 -
NOTE
When the dishwasher is paused during washing, the dishwasher will
beep every minute as a reminder until the Start/Cancel button is pressed
to restart or cancel the cycle
4. Press the Start/Cancel button, the dishwasher will start.