6
IE-SNC-T81(2)xx-01
Press the button again to get value of temperature
corresponding to output current 4mA (output voltage
0V).
After next pressing of the button LCD shows value
of temperature corresponding to output current
20mA (output voltage 10V).
Press button again to end info mode and display actual measured value.
Notice:
during info mode no measurement and no output current (output voltage) generation
proceed. The transmitter stays at info mode 15 s, and then automatically goes back to measuring
cycle.
Procedure of modification of transmitter adjustment:
Device adjustment is performed by means of the optional SP003 communication cable,
connected to USB port of the PC.
It is necessary to have installed configuration program TSensor on the PC. It is free to
download at
www.cometsystem.cz/products/reg-TSensor
.
During installation please take care about installation of driver for USB communication cable.
Connect SP003 communication cable to the PC. Installed USB driver detect connected cable
and create virtual COM port inside the PC.
Unscrew four screws of the device lid a remove the lid. If device is already installed to
measuring system, disconnect leads from terminals.
Connect SP003 communication cable to the device. Display must light up, or at least must light
up all symbols for one second (if LCD was switched OFF by program before).
Run installed TSensor program and select corresponding communication COM port (as
described above).
When new setting is saved and finished disconnect the cable from the device and place the lid
back to the device.
Error States of the device
Device continuously checks its state during operation. In case error is found LCD displays
corresponding error code:
Error 0 -
first line of LCD displays „Err0“. Check sum error of stored setting inside device’s
memory. This error appears if incorrect writing procedure to device’s memory occurred or if
damage of calibration data appeared. At this state device does not measure and calculate
values. It is a serious error, contact distributor of the device to fix.
T8148
T8248
T8148
T8248
