4
WARNING: Risk of fire. Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions. It is not recommended that this heater be placed on
high-pile carpeting or any other surface that impedes the flow of air
underneath the heater.
This heater include an a visual power indicator light to warn that parts of
the heater are getting excessively hot. If the power indicator light flashes,
immediately turn the heater off and inspect for any objects on or adjacent
to the heater that may cause high temperatures. DO NOT OPERATE THE
HEATER WITH THE POWER INDICATOR LIGHT FLASHING.
1. Insert the plug into the suitable wall outlet.
1) Never use the unit in place where is not even, make sure there is nothing
flammable or easy deform object within 1 meter (36 inches).
2) Insert the plug after setting the thermostat to “MIN” position and setting the
power selected switches to “OFF” position.
3) Do not cover the unit.
4) The heater is suitable for operation on an A.C. electricity supply having the
same voltage as that show on its rating label.
2. Rotate power switch to the "Max" position then turn thermostat to the "high"
position, at this moment, the unit begins to work, when the temperature rises to
which you are satisfied with, slowly turn the thermostat counter clockwise until
the power indicating light out, the room temperature can keep constant. If you
want to raise or lower the room temperature, you can either turn the thermostat
clockwise to raise the temperature or counter clockwise to lower the temperature,
or set the power switch to Low position.
3. After use, turn the power switch to the “OFF” position first, then turn the
thermostat to the “MIN” position, and pull out the power supply plug.
NOTES:
1.The pilot lamp will be on only if the temperature is below the setting value of
the thermostat.
2.The room must be sealed in good condition, if not, it will not make good result
because of the influx of heat.
3.The outlets of the control chamber must be kept ventilative, if not, undue move
of the thermostat may occur.
OPERATING INSTRUCTION