BRAVO KIT SYSTEM EXPANDABILITY
of Art. 4660C on Art. 4875KC or 4876KC as described in the
following procedure, and the brackets 5714KC with the
corresponding code (see table on page 39).
For further information on integration of the BRAVO KITS in
Simplebus systems and for programming the main entrance
panel (Art. 4660C), refer to the Simplebus Color catalogue
(Catalogue no. 102), the MT/SBC/01 technical manual and the
FT/SBC/04 or FT/SBC/01 technical sheet.
The diagrams BK/EN/100C and BK/EN/101C on page 90, 92, in
section A of this manual, show a possible system configuration
for managing up to a max. of 30 BRAVO KITS with one Art.
4660C placed, for example, at the entrance of a residential
complex.
With these system diagrams it is possible to call one of the
BRAVO KITS from the main entrance equipped with Art. 4660C.
In this configuration it is necessary to programme the pushbuttons
Programming Art. 4660KC
1.
On the terminal block of module Art. 4660KC, connect the
power supply to ~ ~, set the switch to programming (red)
(see figure 1A).
Connect the terminal block to module Art. 4660KC assembled
as shown above.
NOTE:
For connection between the terminal block and
module Art. 4660KC during the programming stage it is
possible to use the cable Art. 3309, available as an optional
accessory (figure 2).
2.
Set the Dip switches located on the back of the audio-video
module, with the same code assigned to the telephone or
monitor according to the matching described in the
programming table on page 39.
3.
Press the pushbutton to be associated with the telephone call
or monitor. A tone signal confirms programming.
4. At the end of programming, set the switch to standby
(white) (figure 2A).
1
2
3
4
5
6
7
8
ON
DIP
Art. 3309
Fig. 1A
Fig. 2A
Fig. 1
Fig. 2
45
MT KIT 10
E
N
G
L
I
S
H
MT KIT 10
