Comelit 6741W, Техническое руководство, Страница: 13 / 36

13
Advanced configuration
If the standard configuration settings do not reflect requirements, the buttons can be programmed differently by carrying out the
steps below.
After programming, set S2 DIP 1-2-3-4 (PROG) to ON. With these DIP settings, the buttons manage the programmed
functions.
The buttons that are NOT programmed control the functions in row A (table “Standard configurations” ).
Configuring intercom calls
Various types of intercom call can be configured:
• Internal general intercom call
The door entry monitor calls ALL internal units in the same apartment, which have the same user code as the caller.
• External general intercom call
The door entry monitor calls ALL the internal units in another apartment. The user code must be programmed for the internal
units in the apartment to be called.
• Selective single intercom call
This is an intercom call to an internal unit in the same apartment or another apartment identified by a dedicated intercom call
code, different from the code identifying the apartment. It ONLY calls that internal unit. The call code that can be configured
for the selective intercom function goes from 1 to 8; the same intercom call code can be assigned to a maximum of 3 internal
units.
If even a single user configures this function, the intercom call code must be programmed on all door entry monitors on
the riser, even if they do not use the function!
• Selective group intercom call
This is an intercom call to groups of several internal units in the same apartment or another apartment identified by a
dedicated intercom call code, different from the code identifying the apartment. The internal unit button can be configured
with up to 3 different intercom call codes to which the call will be made at once. The maximum number of internal units which
can ring simultaneously nevertheless remains 3.
General intercom and selective intercom CANNOT be programmed in the same system!
• Two-family intercom (INTb)
When this function is configured, if user code 1 has been assigned to the internal unit making the call, this unit calls the
internal units to which user code 2 has been assigned and vice-versa, if its code is 3 it calls 4 and vice-versa, etc.
General internal intercom call and general external intercom call: button configuration
The button for the General internal intercom call function can also be programmed using the procedure described in the
section “Configuration via the menu” on page 18 .
1. Make a note of the S1 DIP-switch settings.
2. To enter programming mode, set S2 DIP 6 to ON.
» the LED flashes
S2
3. Refer to the table “Standard configurations” to identify a DIP-switch 1-2-3-4 combination
in which the intercom function (INT) corresponding to the button you want to program
appears, then set the S2 DIP-switches.
Example: For button X= Intercom (INT) set S2 DIP-switches 1-2-3-4 as specified in row
"N" in the table “Standard configurations”
Example
S2
4. Set the S1 DIP-switches according to the call address of the desired apartment.
See “Addressing table” on page 6
< BACK