3
Chapter 2 — Installation and Configuration
2.1 Package Contents
AIO (All In One) is design to a compact, small size, hard Dome Camera Housing.
The housing is constructed of aluminum, steel and plastic. The housing is designed to be
mounted both wall and ceiling type.
The housing meets the Protection Classification IP66 standards for dust and moisture resistance.
This housing has one fan and one heater controlled thermostatically.
The thermostat of heater is set to turn it on 5˚(±5) and to turn it off 15˚(±5).
The Sunshield is available for application to avoid the direct rays of the sun.
Dome Camera housing
………………………1
Instruction Manual (This Document)
………………………1
Torx Wrench
………………………1
2.2 Installation
You need one optional mount kit of the wall mount and the ceiling mount to install.
The wall or ceiling mount must be attached to a structural object such as hard wood, concrete
that will support the weight of the mount and AIO.
The use of a solid backboard is recommended when attaching to gypsum walls.
1. Remove the Protection pad and the tape from attached the dome camera.
2. Attach the mounting base to wall using the supplied M8 tapping screw and plastic
bushing. (Ceiling using the supplied M6 tapping screw and bushing)
3. Wind the both thread of the pipe end with Teflon tape about 20 times for sealing.
Then use a silicone rubber sealant to seal the area where the wall (ceiling)
mount and the pipe meet.
4. Place a bead of silicone sealant around the wall and ceiling mount mounting
flange, press it to the surface and line up the flange hole with drilled holes.
5. Refer to the appendix E and F.
CAUTION : A silicone rubber sealant must be applied to seal the housing to secure
waterproofing