Comelit 20004503, Руководство пользователя

Страница: 9 / 24

9
Special feature when activating DHCP
If you have activated DHCP for the AUDIO MODULE according to the steps mentioned above, please
use the DiscoveryTool as described in chapter "DiscoveryTool" in order to find out the current IP
address configuration of the AUDIO MODULE.
4.6 SETUP MULTIROOM SYSTEM
To establish a multi-room system with AUDIO MODULE and an external Logitech Media Server (LMS),
proceed as follows:
1) Put the Logitech Media Server (LMS) and the first AUDIOMODULE in operation.
2) Change to the AUDIO MODULE configuration menu item "Device Name" and assign a unique
name for the first AUDIO MODULE.
3) Only now connect the second AUDIO MODULE and change the name (see Step 2).
4) Continue with further AUDIO MODULE according to this principle.
Connect all the AUDIOMODULEs one after another, so you can assign each newly connected device a
unique name.
4.7 SETUP ANALOGIC INPUT
Source – Preset. This source will be selected by default after start-up the AUDIO MODULE. This
setting will be overridden if “automatic source selection” is active.
Enable Automatic Source Selection by default. Preset for the “automatic source selection” function.
Note: It is possible that the AUDIO MODULE may also switch to the Line In when an audio cable is
connected without an attached source (open end).
Automatic Source Selection - Default Fallback Source. If the automatic source selection is active,
this source will be the default source after start-up.
Automatic Source Selection - Silence Tolerance (Timeout in Seconds) .The time for which the
AUDIOMODULE will wait before switching back to the default source when it does not receive a
audio signal.
Assures that pauses in or between songs do not causes a source switch.
4.8 SETUP EQUALIZER AND VOLUME
Equalizer. The AUDIO MODULE has10 different in-build audio profiles to adjust the audio output that
can be set using this pull down menu. The chosen audio profile will be loaded into the Digital Sound
Processor (DSP) and activated once you press "Save Configuration".
The profile for the digital sound processor can also be selected here. The selected profile will be
activated after saving the configuration.
Default Volume
•
Line-In. The volume which is used at start-up of the AUDIOMODULE for the source Line-In.
•
Media Server. The volume which is used at start-up of the AUDIO MODULE for the source
Media Server.
Energy Saving Mode - Timeout (Minutes). Applies only the AUDIO MODULE with amplifier.
The time for which the AUDIO MODULE will wait before going into stand-by when it does not receive
a signal.
Notice: The value “0” (zero) disables this feature.