5
Operation and Programming
Art. 1259C
can be used to manage analogue CCTV cameras (up to 3).
Art. 1259C
can be used in systems with Art. 4888C in the SB1 section (running from the mixer power supply unit towards the
external units).
√
With monitor on
f
Press the programmed key to cycle through all connected cameras, in accordance with the diagram below. Sequential
switching can also be activated using a clean contact (C-NO) connected to the INA – GND input.
External
unit
3
rd
camera
2
nd
camera
1
st
camera
GENERIC OR CODED ACTUATOR MODE
MODE WITH AUDIO PORTER OR SWITCHBOARD
In this mode and with the door entry phone monitor switched on, it is possible to cycle through all the connected cameras by
repeatedly pressing the button programmed as
“generic actuator”.
f
Microswitch
“S1”
must be set as illustrated below.
f
Set the number of cameras connected using dip switches 7 and 8, as shown in the table below:
Default configuration
Programming the number of cameras connected
1. Generic actuator mode
MODES
DIP 1
DIP 2
DIP 3
DIP 4
DIP 5
DIP 6
DIP 7
DIP 8
Actuator coded to
address 5 (actuator code
on monitor 225) with 3
cameras connected
ON
OFF
ON
OFF
ON
OFF
ON
ON
DIP 7
DIP 8
0
0
1
0
0
1
1
1
Before programming the module, see
“5. Compatibility table for Art. 1259C”
.
