S
y
s
t
e
m
P
r
o
g
r
a
m
-
l
Press
Dial tone will sound.
Select
toll restriction table entries. Refer to
programming table (Table 3-4) to preselect entry
requirements.
l
Select table with memory key. The dial
tone will stop when the selection is made.
KEY
TABLE
KEY I
TABLE
Al
Al
11
A 5
A 5
55
A 2
A 2
22
A 6
A 6
66
A 3
A 3
33
A 7
A 7
77
A 4
A 4
44
A8
A8
88
l
Select
mode of table
with keypad key.
Tone burst conforms selection.
l
Select
entry line on table
with memory
key. Action clears any current entry and
causes continuous busy tone to sound.
l
Dial
number for entry line. Press key
to enter “match anything” digit. Tone
burst sounds after each key is pressed.
NOTE: An
line can contain a maximum of
16 digits. When the maximum number of digits
are entered, the system sounds a fast
tone, and steps to the next entrypoint on
a
table
or to the next table.
If less than sixteen digits are entered on
line, select next entry location with
memory key.
l
Repeat procedure for each desired toll
restriction table.
NOTE: Select an
line even if no input is re-
quired. This action insures that any previous
entry is cleared. Select a table and then select
each line in the table to clear the table of
entries. Do not dial any numbers after the entry
line selections.
l
Press
9 .
Program
data speed baud rate
for printer port.
l
Press 3 to set data speed of 300 baud.
-or-
*
Press 0 to set data speed of 110 baud
l
Press
10. When the system stores a dialed number for later
it automatically stores a pause each time
the user waits a period of time between digits.
(The length of the stored pause was programmed
in step 4.) To program
length of time to
is inserted, proceed as follows:
l
Press
7 4 6
to enter program-
ming mode.
l
Press RECALL..
l
Press keypad key 1 to set wait time to
750 milliseconds.
-or-
*
Press keypad key 2 to set wait time to 2
seconds.
l
Press
11. Press
to exit system COS program-
ming mode.
.
3-4
