Comdel CX600 Series, Руководство пользователя

Страница: 4 / 19

3
The WARNING heading used in this manual explains dangers that might result in personal injury or death. Always
read the associated information very carefully before performing the indicated procedure.
The
CAUTION heading used in this manual explains hazards that could damage the unit. Such damage may invalidate
the warranty.
MUST – This word is understood to indicate a mandatory condition.
HIGH VOLTAGE – Voltages greater than 50 volts DC or 25volts AC and known to cause death or serious injury if
contacted.
SERVICE – Any operation of maintenance, repair, calibration or similar activity other than the normal operation of the
unit.
QUALIFIED SERVICE TECHNICIAN, QUALIFIED ELECTRICIAN, QUALIFIED PERSONELL – These terms indicate
persons specifically trained to install, service or other wise handle electronic equipment of the character and hazard
potential of this unit.
End User Labeling
The system installer should obtain and apply all appropriate safety and warning labels required by the end user’s local
fire department jurisdiction and Occupational Health and Safety Administration over and above those supplied by the
generator manufacturer.
Read And Understand This Section Fully Before Installing or Operating This Equipment.
WARNING: This equipment must be installed, operated and serviced only by trained, qualified persons.
General Safety Requirements
•
WARNING: Hazardous Voltages and RF voltages are present inside this unit, which may cause injury or death. To
prevent electrical shock and or RF burns, never operate this equipment with the covers removed. Never operate
without an appropriate cable connected between the RF output connector on the rear panel and the load.
•
CAUTION: There are no user or operator serviceable parts inside this equipment. Refer all service to a qualified
service technician.
•
This equipment must be bonded to Protective Earth (safety ground) prior to operating the unit. Safety ground
connection must be made at the unit’s rear panel designated 1/4” - 20 threaded ground stud. The ground wire
should be a #14 awg or equivalent (minimum) green/yellow lead.
•
Replace fuses only with identical type and rating parts. Installation and connection of this equipment must only be
performed by a qualified electrician.
•
HEAVY OBJECT CAUTION: A heavy object caution exists for equipment weighing more that
51 lbs or 23 kg. Use lifting aids to install unit, such as chain lifts or hooks and straps, attached to the four handles
at the sides and front of unit. Guide unit into final location using care to keep hands and body parts clear of unit.