Accessory Modules for IL-NT, IC-NT, IA-NT and ID-Lite Global Guide
30
Current conversion table
20 mA/20.0 mA
Primary
Converted
115
119
135
140
155
160
175
181
195
201
Voltage conversion table
100 mV/100.0 mV
Primary
Converted
140
566
170
685
210
842
230
921
250
999
Current conversion table
20 mA/100.0
Primary
Converted
116
60
135
70
155
80
174
90
194
100
Current conversion table
20 mA/60.0
Primary
Converted
0
0
38
12
57
18
77
24
96
30
116
36
135
42
155
28
174
54
194
60
Current conversion table
4-20 mA/100.0
Primary
Converted
38
0
54
10
77
25
100
40
116
50
139
65
155
75
178
90
194
100
Voltage conversion table
4-20 mV/60.0
Primary
Converted
38
0
54
6
77
15
100
24
116
30
139
39
155
45
178
54
194
60
Note:
1. If other sensor not included from this list is configured, the unit returns sensor fail.
2. PC software tool configuration must correspond to jumpers setting.
3. Do not configure inputs 5 – 8 of analog inputs module in PC software tool - Analog inputs.
4. Do not configure outputs 2-8 of analog outputs module in PC software tool - Analog outputs.
Programming Firmware
Firmware upgrade is via AT-link (TTL). For programming is necessary to close jumper BOOT. RESET jumper
is used to reset the device. Close jumper to reset the device. For programming is used FlashProg PC tool.
4.5.5 LED indication
Binary inputs
Each binary input has LED which indicates input signal. LED is shining when input signal is set, and LED is
dark while input signal has other state.
Binary outputs
Binary output LED shining when binary output is set.
