16
DURING WORK
1.
Collocate forward the drive selector (1)
2.
Select the speed movement rotating the knob (2)
3.
Open the cock rotating the knob counter clockwise. The signal lamp of the water comes on only
during the moving period.
9
10
13.
Push forward the brushes manipulator (1) so to lower the base. During the descent, the signal
lamps of the actuator and the brushes motor come on. The brushes base will be in its working
position when the yellow signal lamp (2) comes off..
14.
Press the accelerator pedal. The machine begins to move, the squeegee begins to lower itself and
the suction motor comes on.
During the first metres of operating, check that the brushes pressure is suitable (see further on
under “BRUSHES PRESSURE”), that the quantity of the detergent solution is sufficient and that
the squeegee dries perfectly.
The machine will now start working efficiently until the detergent solution runs out.
Immediately disconnect the emergency lever (1) situated on the left side from the operator and
apply the emergency brake (2), whenever the machine develops operating problems when it is
working.
These commands disconnect all the functions on the machine. To start the machine again,
once the problem has been solved, turn off the key (3), reconnect the connector (1), switch on the
key (3) and lower the parking brake lever (2).
The machine will not start if the operator is not properly seated.
When the solution tank is empty, the signal lamp on the instrument board comes on.
When the recovery tank is full, the suction motor stops. To start it up again, even if the tank has been
emptied, it is necessary to first turn off the main switch key and then on again.
1
2
