COMAC C85B-C100B, Инструкция по эксплуатации, Страница: 11 / 27

38
MACHINE PREPARATION
10. BRUSHES ASSEMBLY
1. Connect the battery connector
2. Turn the key into position ON
3. With the manipulator lift the brushes base
4. Turn the key into position OFF and take it off from the instrument board
(to carry out the operations of brushes assembly with connected current
can cause damage to the hands).
2
1 3
4
5. With the brushes base in lifted position, insert the brushes into the seat
of the plate under the base until the three buttons fit into the holes of
the plate. Turn the brush so that the buttons are pushed towards their
retaining springs until the brush is clamped in place. The figure shows
the direction of rotation for the coupling of the right brush. The left
brush has to be rotated inversely.
WARNING! During this operation make sure that, there are not
any objects or persons close to the brush.
6. It is recommended to invert daily the position of the right brush with the
left one and vice versa. If the brushes are not new and they show
deformed bristles, it is better to reassemble them in the same position
(the right to the right side and the left to the left side), to avoid that the
different inclination of the bristles causes an overload to the brushes
motor and excessive vibrations.