REPLACING THE SQUEEGEE BODY RUBBER BLADES
Ensuring the integrity of the squeegee body's rubber blades guarantees better floor cleaning and drying results, as well as a longer service life for
the vacuum motor. In order to replace the squeegee body's rubber blades, do the following:
1. Extract the vacuum hose (1) from the vacuum nozzle on the squeegee body (
Fig.1
).
2. Completely unscrew the knobs (2) in the squeegee body's pre-assembly (
Fig.2
).
3. Remove the squeegee body from the slits in the squeegee connector.
4. Remove the rear rubber blade compression plate, and release the stopper (3) at the rear of the squeegee (
Fig.3
).
5. Remove the rear rubber blade (4) from the squeegee body (
Fig.4
).
6. Completely unscrew the knobs (5) on the squeegee body pre-assembly (
Fig.5
).
7. Remove the front rubber blade (6) from the squeegee's internal body (
Fig.6
).
8. Repeat the operations in reverse order to reassemble all the parts.
N.B.
: before using the machine, remember to adjust the squeegee body. Read “
ADJUSTING THE SQUEEGEE BODY RUBBER BLADES
N.B.
: it is good practice to replace both squeegee blades, to ensure good results when drying the floor.
6
6
3
3
5
4
4
5
2
1
1
2
REPLACING THE SCRUBBING BRUSH HEAD BODY SPLASH GUARD
If the splash guard rubber blades of the brush head side casing are damaged they cannot work properly, namely they cannot convey the dirty
detergent solution towards the squeegee, therefore the splash guard rubber blades need to be checked. To replace the brush head splash guards,
proceed as follows:
1. Stand on the left side of the machine.
2.
Remove the left splash guard body (1) and move the fixing anchors (2) on the brush head body into the maintenance position (
Fig.1
).
3. Remove the rear rubber blade compression plate (3), and release the stopper (4) on rubber blade compression plate (
Fig.2
).
4. Remove the splash guards (5) from the left splash guard body and replace it with a new one or else turn it around (
Fig.3
).
5. Repeat the operations in reverse order to reassemble all the parts.
6. Repeat the operations just carried out also for the right side casing as well.
1
3
2
2
3
1
4
5
EXTRAORDINARY MAINTENANCE WORK
Before performing any routine or extraordinary maintenance operation, proceed as follows:
1. Take the machine to the maintenance area.
N.B.
: the place given over to this operation must comply with current environmental protection regulations.
2. Make sure the machine is in a safe condition (see chapter “
CAUTION
: it is recommended to wear the appropriate PPE (Personal Protective Equipment) for the work to be carried out.
31
Содержание C100 ESSENTIAL Series
