Columbus V - 990 Mark II, Руководство пользователя, Страница: 21 / 40

Before using this function, always adjust the camera clock to the synchronized GPS time. Refer to P.15 for the
detailed operation.
After the time is accurately adjusted, you can bring the device together with the camera and take photos.
Refer to P.29 on how to view photos on a map. The symbol of a photo point is "
"
in the map software.
If the speed of the car you are driving exceeds the predefined value of the device, the speaker continuously
emits sharp audible alarms until the traveling speed falls below the value.
You may manually cancel the alarm. All you have to do is to short press the POI button, thereby temporarily
turning off the over-speed alarm function.
When you drive your car at a high speed, this provides you with the convenience to control the maximum
vehicle speed solely with the audible alarm of the device without occasionally checking the speedometer
reading, thereby ensuring driving safety.
Note: Over-speed alarm is only available when the track log function is turned on. Refer to P.27 on how to set the predefined
speed value.
Over-
speed
Alarm
21
Geo
Tagging
Logging Your Journey
Over-speed Alarm
Motion Detecting Mode
Integrating Photos with a Map
Integrating Photos
with a Map
Over-speed Alarm
V-990 will remember the last working mode.
The motion detecting LED turns on in this mode.
When the device is stationary, the led is on. When the device is in motion, the led is flashing. When the device
stops moving or loses the satellite signal more than 5 minutes, the device enters standby mode automatically.
In standby mode, once the V-990 detect motion, the device automatically wakes up and continues to track.
This mode is suitable for long time records of vehicles and other large objects.
G
sensor
Motion Detecting Mode